Panel saw

panel saw
Brand: Biesse
Type: Selco WNT 630
Year of manufacture: 2022


Technical data
- working size 3800x2200 with back lift table
- Max cutting lenght: 3800 mm,
- Saw blade projection: 108 mm,
- Max gripper opening: 100 mm,
- Min panel size: 1830 x 915 mm,
- Max panel size: 3660 x 2200 mm,
- Max packet hight: 630 mm,
- Min. thickness on lift table: 10 mm,
- Lift table max lift: 985 mm,
- Lift table capacity: 5 t
- Main saw motor: 18.5 kW
- Scoring saw motor: 2.2 kW
- Main saw blade: Ø 400 mm, 1 included
- Scoring saw blade: Ø 200 mm with trapezoidal teeth, 1 included
- Saw blade lift driven by a brushless motor and ball screw
- Pressure beam opening control
- DIGISET electronic alignment of the scoring blade with the main saw blade
- Scoring unit can be disabled from the control panel
- QUICK CHANGE system for both saw blades
- Saw carriage travel speed: 1-160 m/min, brushless drive
- Maximum pusher speed: 90 m/min, brushless drive
- Side alignment unit integrated into the saw carriage (0 mm + 3,500 mm as specified in the quotation)
Loading and unloading equipment
- Rear loading onto the lift table with powered rollers and automatic stack positioning at the zero point
- Powered rollers on the lift table for side loading
- Right-side loading and unloading with continuous operator control
- Two panel-counting devices for automatic loading of thin calibrated panels from 2.5 mm thick
- Automatic detection of the bottom support panel based on the thickness set in the machine parameters
- Six liftable pneumatic grippers in the standard configuration
- Two additional liftable pneumatic grippers with double lower fingers for mounting on the pusher
- Two pusher contact points
- Two front alignment stops
- Eleven standard roller modules and two additional roller modules with wheels
- One 2,050 × 850 mm unloading table with non-powered rollers, replacing the standard 2,050 × 620 mm air flotation table
- Two additional rounded air flotation unloading tables, each 2,050 × 620 mm
- One fan serving up to six air flotation tables
Control, maintenance and safety
- Windows-based PC control with flat-panel monitor, keyboard and mouse
- OSI Plus interface
- Panel measuring system for manual cuts
- Remote cycle start button with safety stop, located at the second or third table
- Automatic lubrication
- Safety guards and protective devices

The machine is almost new and was used only for a few months.



Note:
The technical data and descriptions are copies of the order confirmation at the time. The information is for informational purposes only and is not binding.